2004 Jeep Grand Cherokee Left Turn Signal Not Working. Probably a bad ground on your front right signal, or a bad bulb. My hazards still work as do the parking lights.
Replaced bulb still not working so replaced with a. Consider to support my channel and all the hard work put into it at. Has to be done manually;
Web To Check This, I Set The Multimeter To Measure Volts, Turned The Turn Signal On, Put The Positive Probe On The Positive End Of The Battery And Tested Both Terminals Inside The Light Socket With The Negative End, And For Both Terminals, It Completed A Circuit And Showed Me 12+ Volts.
Could this be a problem with the switch or what? Replaced bulb still not working so replaced with a. Probably a bad ground on your front right signal, or a bad bulb.
Web #1 · Feb 2, 2015 The Other Day I Noticed That My Left Side Turning Signal Just Magically Stopped Working.
Web 3 answers 90 guru8fk1t answered 3 years ago relay on the jeep. If it stops while you’re doing this then it’s the relay. I first of all checked to see if the light was blown, and it wasn’t.
Has To Be Done Manually;
Try switching the right with the left, and see if the problem stays in the same place, or goes with the bulb. So i changed the flasher relay (part no. Web 2004 jeep grand cherokee left rear only turn signal/flasher not working.
Web Handy Rubber Mallet:
Web i have a 2004 jeep grand cherokee 4.0. You can donate on the main channel page. Web enjoyed the video or found it helpful?
My 2000 Jeep Grand Cherokee Done Same Thing.
It would occassionally go back to working and then stop again. My hazards still work as do the parking lights. What i did to test this was turn the key to the on position, put the left turn signal on and if hyperflashing just try and push and pull on the relay ever so slightly.