Maytag Washer End Of Cycle Signal Not Working. We found that the lid switch assembly was no longer working on. You may also visit www.maytag.com/connect.
So i noticed a couple of months back that the cycle signal/buzzer/beeper what ever you want to call it wasn’t working. If it has, reset it. To check the drain hose, first, disconnect your maytag washing machine from the power source.
Then, Access The Drain Hose And.
Touch to turn the end of cycle signal on/off and adjust the tone. Hold this button no more than 3 seconds. Web possible solutions beeps and tones:
If It Has, Reset It.
Use the end beep button on the control to make changes to the tones as described below: We found that the lid switch assembly was no longer working on. Web cycles with lower spin speeds remove less water than cycles with high spin speeds.
Web How Do You Make The End Of Cycle Sound Louder On Front Load Washer And Dryer?
Unless you're standing right in front of the washer or dryer you can't hear it. First, reset your washing machine. When no signal is heard, the signal is off.
Press The Signal Button Repeatedly To Adjust The Volume Of The Signal.
If damaged, replace the lid switch. During this time “oob” will briefly be. To check the drain hose, first, disconnect your maytag washing machine from the power source.
Have You Checked If The Drain Hose Is Clogged?
How old is your washer? What's the brand and model of your washer? Nothing changed with the unit other than it had.